The bases in dating dating chrishell
In any event, the suction scar is found on mouth-blown bottles though suction scars are sometimes referred to as a pontil scar by the unfamiliar.
See the machine-made section of the Bottle Bases page for more information on these scars. with distinct suction scars were likely Owens machine produced.)6. Machine-made bottles tend to have few if any bubbles in the glass and the thickness of the glass is usually more uniform throughout the bottle as compared to mouth-blown bottles.
There are at least two additional finish related mold seams - one at the top of the finish which encircles either the bore or sometimes the outside of the upper lip portion of the finish (sometimes of these seams are present) and a horizontal seam immediately below the finish which circles the extreme upper neck (called a "neck ring parting line").
(Mold seam thickness and how high it protrudes [height] is of only moderate use in telling a machine-made bottle from a mouth-blown bottle, though if a bottle fragment has a hair fine mold seam, it is highly likely to be from a machine-made bottle.) 3.
There are also no horizontal tooling marks present on the finish and/or upper neck as would be observable on the finish of mouth-blown bottles.2.
The side mold seams on most machine-made bottles tend to be finer (narrower and lower) - though sometimes sharper and/or visually distinct than mouth-blown bottle mold seams although many mouth-blown bottles have very thick and distinct seams due to less precise mold construction or fitting.
Both seams are quite diagnostic of machine manufacture and are usually visible, though the seam at the top of the finish can be hard to see on some bottles - especially if the finish was fire polished.
In the glassmaking trade, these seams along with the side mold seams within the finish or just below are referred to as "neck ring" or "neckring" seams since they were formed by the separate neck ring portion of a machine mold (Tooley 1953).
(Note: It is likely that other types of suction based automatic bottle machines made in Europe in the 1920s - and possibly later - also produced a suction scar on the base of their products [Pearson 1928]. The presence of a circular valve mark on the base of a bottle (typically a wide mouth bottle or jar) is sure evidence of machine-made manufacture by a press-and-blow machine. This is especially true of later machine made bottles, i.e. (Note: The presence or absence of bubbles in the glass and relatively even distribution of the glass throughout the characteristic is not a primary feature of either machine-made or mouth-blown bottles, though there are strong trends.