Questions to ask on internet dating site
But then there were the engines acquired by both companies from other railroads, and on infinitem.The greatest amount of lumber used for one project was the 37 miles of Snow Sheds, as mentioned above.I can imagine that the Union Pacific's requirement was about the same so — for the total mileage of the transcontinental railroad of 1776 miles required 177,600 tons (metric tons) of rail for the track alone. more that a standard 2000 lb ton andthat if you reported the railtonnageat a 2,000 lb./ton the total rail weight alone would weigh198,912 tons of iron rail. Just remember that in the 1860's that rail was measured by the metric ton but bolts, spikes and rail fastenings were measured by the standard 2,000 lb. Then you would have to add the weight of spikes bolts, rail chairs, fish plates (rail fastenings).
(Not sure if the weights of locomotives listed are shipping weight or maximum track loading including water.) If you estimate from the available data that about 21,000 miles of track were put in place during the 1860's in the U. and that the amount of iron used is proportional to the track miles built, then the percent of iron used in building the transcontinental railroad (compared to all U. railroads' iron use during 1860's construction) is about: (1,776/21,000)*100 = 8.5% According to Galloway: "The number of ties varied from 2,260 to 2,640 per mile, depending upon alignment and grade. The total completed length of the sheds and galleries was about thirty-seven miles, the building of which consumed 65,000,000 feet board measure of lumber and 900 tons of bolts, spikes, and other iron." of rail was accounted for, as shown by a letter from Collis P.Details, at 60 lb/yard (per single rail) single track from Omaha to Sacramento: 1776 miles x 60 lb/yard x 5280 feet/mile x 1/3 yards/feet x 2 rails x 1/2000 ton/lb = (1776*60*5280*2)/(3*2000) = 187,546 tons of iron.If the rail is 56 lb/yard, then the total rail weight is about 175 thousand tons (about a hundred tons of rail per mile).they weigh 3,355,170 pounds-which is 29,190 pounds less than your invoice ...' ...can you imagine the labor of weighting 3 million, three hundred fifty five thousand, one hundred an seventy pounds of rail? Strobridge comments: I can't speak to the Union Pacific rail but can add to the information on the Central Pacific's 690 miles of "Iron." Here is some information on the Central Pacific track.
The UPRR's engines were a little heavier, ranging from 54,500 to 93,300 lbs for an approximate average of about 75,000 lbs.